|
APT7801 - 7 PC. SENSOR SOCKET SET
Includes Plastic Molded Case
Mfg: Astro Pneumatc
- Includes plastic molded case
- Set includes:
- 1" and 1 1/16" Oil Pressure Sending Unit Socket Includes a 1" and 1 1/16" hex which allows the removal of oil pressure sending units. Special deep design fits switches up to 2 5/8". Designed to be used with a 3/8" drive tool or 1 1/8" wrench
- 1 3/16" Oil Pressure Sending Unit Socket Allows the removal of oil pressure sending units on late 1980 and mid 1990 GM vehicles. Designed to be used with 1/2" drive tool
- 1 1/16" GM Thermal Sensor Switch Socket Allows the removal and installation of thermal sensor switch on 1973 - 1977 GM vehicles. Designed to be used with 1/2" drive tool
- 7/8" Heated Oxygen Sensor Socket Socket designed with slot in socket which accommodates the connectors on heat oxygen sensors. Socket has a double 1/2" drive for easy access.
- 7/8" Low Profile Offset Oxygen Sensor Socket Low profile design for use in tight spaces. Designed to be used with 3/8" drive tool.
- 7/8" Oxygen Sensor Socket Socket designed to remove and install oxygen sensors in most domestic and many imported vehicles. Socket designed with slot which allows clearance of wire. Designed to be used with a 3/8" drive tool or 1" wrench.
- 7/8" Universal Vacuum PVS, TVS Valve and Oxygen Sensor Socket Designed to remove and install vacuum switches with a 7/8" hex and some oxygen sensors. Designed to be used with 3/8" drive tool or with a 1" wrench.
|
|
|
LS12230 - OXYGEN SENSOR THREAD CHASER
Cleans Threads in Oxygen Sensor Holes
Mfg: Lisle
- Cleans Threads in Oxygen Sensor Holes
- Use with 3/4" hex socket or 3/8" square drive
- Size: M18x1.5
- Works on M18x1.5 spark plug threads
|
|
|
LS34350 - WATER SENSOR WRENCH FOR DURAMAX
Removes & Installs the Water Sensor on '01 and
Newer 6.6L Duramax Diesel Engines
Mfg: Lisle
- Removes & installs the water sensor on 2001 and newer 6.6L duramax diesel engines
- Use when replacing the fuel filter or when servicing the water sensor
- Plastic sensor has a 12 sided design that is easily damaged by tools,
like pliers, that do not specifically fit the sensor
|
|
|
LS43900 - PNEUMATIC OXYGEN SENSOR REMOVER
Works Where Conventional Sockets Wont
Mfg: Lisle
- Works where conventional sockets wont
- Use with air hammer to remove stubborn, baked-on oxygen sensors
|
|
|
LS48500 - PUSH ROD REMOVER
Works on GM V6 2.8L, 3.1L and 3.4L Engines
Mfg: Lisle
- Works on GM V6 2.8L, 3.1L and 3.4L engines
- Quickly removes push rods so you can replace the intake gasket
- No need to loosen and retighten the rocker arm
- The tool pivots the rocker arm to compress the valve spring and free the push rod for removal
|
|
Bookmark
)
)
)
)
)
